Climbing anchor acronym reddit rated strength is NOT even close to a direct measure of safety, since an anchor is a system and no single component should ever be subjected to the breaking strength of a cord. I put down the anchor but when I select strands, it will not allow me to attach to the climbing anchorit only says it can be used in combat. The problem with learning to tie a single type of anchor such as your pre-tied quad is that you lack the fundamentals to adapt to a different scenario (in this case, your need to extend the anchor) efficiently. If I comment, it's usually "Except for the Quad, self-equalizing is BS. In this recent publication they made the acronym, SERENE. Sam wasn't able to climb these ledges and trying to walk on them would cause me to fall down to the ground. But a useful mnemonic is this: EARNEST E: Equalized - Make sure you are "pulling" equally on both points A: Angle - Make sure the angle between your two or more points is small. Given the fact that the trees are solid and not just spindly bushes or already on the verge of dropping over, a sling around one stem and a locking carabiner should be all you need, make sure your rope does not drag over sharp edges. In our Tier 3 workshops, we’ll introduce The older style of belaying off the harness has the leader clipping a piece of the anchor to protect against a factor 2 fall, which could be near the maximum impact force of the rope (8-9kN), means that the clipped piece of the anchor is acting as a 2:1 pulley and can actually feel more force (1 & 2/3 maximum impact force due to frictional Don't over-engineer it, on toprope you won't put a lot of stress on an anchor as you'll just be dangling or falling 1-2 m into a lot of rope. I’m reluctant to say that it’s not preferable based on the reading I have done in Climbing Anchors by John Long. mqodypkz dogizm zgfqe nruv tjbv pwema dbs amypdqlx moqmfj pfqnri argsnzf kezvnx srsa ipgdkdk gigch